|
Type: |
Gas
instantaneous, power vented. Full
gas modulation temperature control.
|
|
Dimensions: |
11.5" Wide x
13.5" Deep x 14.25" High.
Weight: 27.5 lbs
full
|
|
Hook-ups: |
Electric:
18-2 x 2' lead.
Gas:
Brass 3/8" flare inside case, rear accessible.
Water:
1/2" OD copper tubing.
Brass compression to 1/2" NPT elbow can be installed or as
specified.
|
|
Capacity: |
55,000 Btu input - 44,000
Btu output at maximum burn at 8.5 WCI manifold pressure.
15,000 Btu input - 10,600 Btu output
at low burn at 1.2 WCI manifold pressure.
(88°F
temperature rise per gallon per minute continuous flow at high burn).
|
|
Fuel
Consumption: |
2.55 lbs per hour at
maximum input. ( At 2 GPM
of water, 20 lbs of propane will produce over 940 gallons of hot water).
|
|
Mounting: |
Side mounted keyed bracket.
Left or right side mounted
|
|
Clearances: |
Zero clearance top
(blower), bottom and sides. 2"
in back for hook-ups. Enough
space in front to remove cover for service
|
|
Flue: |
“3”
power vent with proofing switch. (3”
stainless flex duct recommended to the outside and can run up to 25')
|
|
Construction: |
Modular: Three assemblies;
gas, electronics and water.
Burner:
High primary air, 12 element, atmospheric type.
Aluminized steel body with stainless flame strips.
Heat exchanger: Copper fin tube type
with wrap for cooling.
Electronics:
Plug in, potted, works-in-a-drawer.
Case and flue assembly are stainless
steel.
|
|
Fuel: |
Propane at 11 WCI
|
|
Power: |
12 VDC at 4 amps while running, 40
milli-amps in standby. # 12
power line recommended.
|
|
Water
Temperature:
|
Factory
set at 115° F. Can be
field adjusted 90° to 135°F.
|
|
Mounting: |
Mounting flanges included. Must be mounted in accordance with any applicable
Coast Guard and ABYC recommendations.
|
|
Safety
Features: |
The
Shower-Mate is pilotless. There
is no flame unless water flow is sensed.
Flame rectification: Gas valve shuts
off in .8 of a second if there is a flame outage.
Redundant gas solenoid.
Electronic high temperature shut-off
(two).
ECO high temperature shut off @ 165°F
with manual reset.
Pressure relief valve at 100
PSI.
Power vent must proof fluing before
gas valve opens.
|
